Koji cpu kuler od ova 3?

[vylota]

Hteo bih da kupim jedan od sledeca 3... ZA C2D

1. OCZ VENDETTA
2. OCZ VANQUISHER
3. THERMALTAKE TMG i1

znam da je (1) najbolji, ali je i oko 10e skuplji... da li je toliko bolji od druga dva, koji se najlakse montira?
pozdrav

 

[Rax13]

Ma Vendetta...

 

[vylota]

Kakvi su po tezini u gramima??

Kakvi su po tezini u gramima??

 

[illidan]

vendetta ili vendetta 2 ?

 

[vylota]

vendetta

vendetta, 2 je prevelik

 

[illidan]

120mm je 120mm

 

[d0minat0r]

vendetta, 2 je prevelik

vendetta ili jos bolje vendetta 2

zasto ti je vendetta 2 prevelik ? ? ? :trust:

 

[activated1]

mozda ne moze da zatvori kuciste, drugi razlog ne bih mogao da nadjem...

 

[vylota]

evo zasto...

Razlika je oko 500-600 dinara, a izgleda da je par stepeni u pitanju, plus dosta je veci sto se moze videti na sledecem linku, ali je 2ka tisha...

http://techgage.com/article/ocz_cpu_cooler_roundup/

 

[vylota]

A evo i jos veceg razloga...

Kopirao pa preneo sa testa sa overclockersa...

http://www.overclockersclub.com/reviews/ocz_vendetta_2/

sa zadnje strane testa pishe:

The biggest problem that I found with the OCZ Vendetta 2 is, that when installed on my Gigabyte X38 motherboard, the cooler covered slots one and two for the memory unless the fan was pointed to the rear of the case, which then slot one was the only one covered. For an AMD system, the fan can only be installed pointing up or down due to the retention bracket, so slots one and two will be blocked again. This happened when I tried the cooler on an AMD 780G board. This inhibits a user from possibly using thier memory in dual channel, unless they have a motherboard with the RAM slots farther from the CPU slot. I tried the cooler on three different motherboards with several different sets of RAM, and all had the same result. The fins of the heatsink would come in contact with the PC Board of the memory, not allowing a flush contact with the CPU. Also, because of the size of the heatsink, it is a tight fit in my full size ATX case, and might be too big for some smaller cases. If you have the room to spare in your case, then the OCZ Vendetta 2 is an ideal cooling solution.

 

[c-p-r]

Pa nemas ti tu plocu, kod mene recimo pokriva samo jedan slot :d

Fan je ok, fino duva, a na preko 1k rpm se spolja ne cuje.